Yep, nightmare. Set the wrench to 10nm and the damn bolt snapped without much resistance, aluminium rubbish. Would it be because they are supposed to be single use?
Anyways, I am going to try and extract it as is. However, I can see that the bit left in would be proud of the casing if I took the cover off so that might be the way forward if extracting as is does not work. Is there a pandoras box of horrors if I take the casing off, or would it be ok?
And has anyone replaced these alu bolts with something better, I am considering ti from pro bolt?
Any advice on this most annoying issue much appreciated.
Anyways, I am going to try and extract it as is. However, I can see that the bit left in would be proud of the casing if I took the cover off so that might be the way forward if extracting as is does not work. Is there a pandoras box of horrors if I take the casing off, or would it be ok?
And has anyone replaced these alu bolts with something better, I am considering ti from pro bolt?
Any advice on this most annoying issue much appreciated.