Fitting carbon frame sides but need to remove fairings

[cre0108]

As per the title i have bought carbon frame covers but they fit underneath the fairing at the front. Can i just remove the top part of the fairing and is it easy to do? I believe there are two plugs female and male plus bolts? Any advice would be appreciated
Chris

Sent from my SM-G935F using Tapatalk

 

[alex]

You'll have to remove the bellypan and the sides.

 

[Budgie]

Like Alex says you'll have to remove sides and belly but it's easy to do mate.

 

[alex]

Looking fwd to your review on these btw! Fit etc around the holes and the frame welds etc

- Alex

 

[cre0108]

Looking fwd to your review on these btw! Fit etc around the holes and the frame welds etc

- Alex

Will do . Any guides to removing the fairings ?

Sent from my SM-G935F using Tapatalk

 

[roadrunner]

Will do . Any guides to removing the fairings ?

Sent from my SM-G935F using Tapatalk

Only the obvious
Very carefully is the name of the game. The bits that pop in to the rubbers can be brittle and quite easily broken I?ve heard.
Try to see where these are and try to get your fingers each side and as close to the popper as possible. Then gently and evenly ease them apart.
I reassemble using rubber lub to make the job not so scary the next time

Just be careful and don?t rush it and you should be fine.
Hope this helps

 

[Monners]

As above its easy to do but the different tabs can be broken without too much force. The poppers are to the upper rear of the side panels and pull out.

 

[Billo01]

When re-assembling don't over-tighten any screws especially those that fix the side panels to the belly pan as tabs that hold the metal clips easily snap

 

[stuartb]

Piss easy removing and replacing each part.... I used a 3/8 drive ratchet, extension and matching Torx/Allen sockets to undo the fasteners.. I bought a box of Clips, fasteners off EB and replaced them all one by one...bit of silicone spray lube on the fingers that slide into the rubbers helps but not critical... nip up each fastener by feel...



Sent from my SM-G975F using Tapatalk

 

[cre0108]

Cheers guys . Thanks for advice will report back on fit etc on these carbon frane covers and the rear swing arm covers.

Sent from my SM-G935F using Tapatalk

 

[oldwobbler]

I need to get some of these for my next bike - before I ride it!!