Gen1 expert help needed, cant switch modes, not a controller/button problem

S1000RR  FORUM

Help Support S1000RR FORUM:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

gorgh

New member
Joined
Feb 28, 2020
Messages
2
Reaction score
0
Hi,

So, long story short, track bike gen1 2010 RR.

No ABS unit present, no traction control since day 1.

I had no LAMP! error written on the dash, slick mode obviously selected all the time.

Bike was working fine in Slick mode, well and without any troubles for whole of his lifetime untill I crashed it heavily in July. The bike went straight on into the barrier reversed, at the crash fuel tank flied off, ECU was unpluged st the hit and airbox was destroyed as well among other things.

Since the crash the bike did not start, we inspected the ecu all good, we inspected all the wiring all good and last week we tried another throttle body and it started fine and runs perfectly, so it was a problem in the throttle body.

Now when i turn the bike on I have in mode RAIN and cant select/confirm the SLICK mode no more...i can go through all 4 modes but once it should be selected....nothing happens, remains in RAIN mode.

Also, now I have LAMP error written where the water temp was before....

Among the above mentioned damagee electrical parts, i also lost in the crash the white lean sensor box for Tracton control which is behind the battery. - angular sensor error is this one I guess.

But since the bike already did not have tc/abs before I dont see this can be the cause....

So, I have pulled the codes with software, I assume one of the codes are preventing the ecu to select any other mode - could this be the problem? See below:

Hmm...looks like i am too dummy to upload the photos, but ok, can be seen on the links below:

https://ibb.co/tKwbtJX
https://ibb.co/jVfYtTG

Can anyone help if any of the codes below could be the reason of bike not switching to switching to SLICK

Also maybe worth mentioning - when I give ignition on, on right side are displayed all 4 modes and slick mode is selected/highlighted, but once dash startup initialization is over RAIN mode is selected/shown on the right side.

Video for better understanding

https://youtu.be/5-8McFDAdI0

Many thanks!
 

Latest posts

Back
Top