torque settings for cliponns and top yoke pinch bolts

[cally1066]

As above does anybody have these torque settings as im trying to cure my handlebars vibrating thanks

 

[Niven770]

19nm for standard, clip on and top yoke.
18nm for harris

 

[Niven770]

Tightening torques 0507 - S 1000 RR

Equipment trim-level variant:

0128
-
BMW Motorrad Race ABS

0129
-
BMW Motorrad Race ABS and DTC



00 00 111 BMW Service




Description
Value
Valid



Oil filter to engine

Coat seal with engine oil
11 Nm



Oil drain plug to oil pan

M16 x 1.5
28 Nm



Threaded plug to timing-gear cover

M32 x 2
10 Nm



Cylinder-head cover to camshaft bearing assembly

M6
10 Nm



SLS gallery to cylinder-head cover

M6 x 16
4.5 Nm



Intake air silencer to throttle-valve assembly

M6 x 14
8 Nm



Intake air silencer to frame

M6 x 25
8 Nm



Actuator motor to intake air silencer

PT K 60 x 22
3 Nm



BMS-K bracket to main frame

M5 x 25
5 Nm



Fuel tank to retaining bridge, rear

M6 x 115
5 Nm



Fuel tank, front, to frame

M6 x 40
5 Nm



Adjusting screw in timing-chain tensioner

Special tool for adjusting timing
1.2 Nm



Threaded plug in crankcase (bore for locating pin)

M10 x 1
15 Nm



Timing-chain tensioner to cylinder head

M24 x 1.5
15 Nm



Spark plug to cylinder head

M10 x 1
12 Nm



Damper unit to slider tube

M10 x 1.25

Loctite 243
30 Nm



Nut to damper unit
20 Nm



Cover to fixed fork tube
20 Nm



Fork bridge, top, to fork fixed tube

M8 x 25
19 Nm



Fork bridge, bottom, to fork fixed tube

M8 x 35
19 Nm



Handlebar half to fork leg

M8 x 25
19 Nm



Bracket, reservoir to fork bridge

M6 x 12
8 Nm



Bracket for wheel-speed sensor to fork leg

M5 x 10 - 10.9, Replace screw

Micro-encapsulated
5 Nm
– with BMW Motorrad Race ABSOE (0128)



or

– with BMW Motorrad Race ABS and DTCOE (0129)





Wheel-speed sensor, front, to bracket

M5 x 14
5 Nm
– with BMW Motorrad Race ABSOE (0128)



or

– with BMW Motorrad Race ABS and DTCOE (0129)





Quick-release axle in threaded bush

M24 x 1.5
50 Nm



Clamping screws in axle holder

M8 x 35
19 Nm



Radial brake caliper to axle mount

M10 x 65
38 Nm



Front-wheel cover to slider tube

M5 x 14, Replace screw

Micro-encapsulated
2 Nm



Bleed screw on handbrake fitting

M7
5 Nm



Bleed screw, front, in banjo bolt

M6 x 1
6 Nm



Rear brake caliper bleed screw

M10
14 Nm



Clutch lever fitting to handlebar

M6 x 15
8 Nm

 

[cally1066]

great , thanks bud

 

[soofsayer]

Anyone know the Gilles / hp brake and clutch pinch bolts torque to the bars? Is it 8nm both sides?