Looking to install the 2D front sensor to the HP4, in a slightly different way than intended. Can anyone advise what significance "the distance of 412mm between the two ball ends"?
Is there any impact if this value is +/- XX mm, if so is there any way to compensate or adjust to suit the installation? There is also the consideration I can get the 150mm or 175mm derivatives?)
For some background as to what I am trying to achieve, i'm looking to install the sensor on the rhs of the bike (not reversed / cable at the top), with the alpha racing carbon bracket at the bottom of the fork leg. And for the top to a sensor mount on hte back of the bolt for the lower triple clamp (as they are now doing on the 2019+ K67 models/installation kits)
Anyone with their comments and/or experience of these items, and what I am trying to achieve is if at all possible your time and words much appreciated
Is there any impact if this value is +/- XX mm, if so is there any way to compensate or adjust to suit the installation? There is also the consideration I can get the 150mm or 175mm derivatives?)
For some background as to what I am trying to achieve, i'm looking to install the sensor on the rhs of the bike (not reversed / cable at the top), with the alpha racing carbon bracket at the bottom of the fork leg. And for the top to a sensor mount on hte back of the bolt for the lower triple clamp (as they are now doing on the 2019+ K67 models/installation kits)
Anyone with their comments and/or experience of these items, and what I am trying to achieve is if at all possible your time and words much appreciated