GixxerChuck
Forum Vendor
Bike has been repaired at last from the accident in May. Exhaust was replaced so had to take the baffle out again. This time did it in about 5 minutes!
I cannot emphasise how much better the bike sounds after doing this. Much better overrun popping and on down change.
Also did it without marking the exhaust. Use a dremel to break the weld in the screw hole and then lever it out with a flat head screwdriver inside the screw hole again. This should loosen it enough to get a larger screwdriver behind the baffle with something against the exhaust to protect it. Gentle wiggles and she's out :emmersed:
I cannot emphasise how much better the bike sounds after doing this. Much better overrun popping and on down change.
Also did it without marking the exhaust. Use a dremel to break the weld in the screw hole and then lever it out with a flat head screwdriver inside the screw hole again. This should loosen it enough to get a larger screwdriver behind the baffle with something against the exhaust to protect it. Gentle wiggles and she's out :emmersed:
