2012 S1000RR PCV Install problem

[pclement5]

Hi All,

Installed a PCV today and followed the instructions really carefully, bike starts and I can see the PCV on my laptop and send maps to it however when I turn on the ignition or run the bike the TPS count in the power commander app counts up from 0 to 96 and then sits at 96.

Triple checked the wires I attached the posi-taps too and I'm sure they are right and properly attached.

Disconnected both the TPS and the Gear position sensor and noticed it still does exactly the same thing, any ideas about what I could have done wrong?

Thanks!

 

[pclement5]

School boy error, attached the POSI tap the wrong way round as it came apart whilst I was installing it. The pointy end goes into the bike wiring. Lesson learned, pretty obvious now <slaps forehead>.

 

[paradoc]

man i take it all is well now how was your drive back from CWs

 

[pclement5]

Yep all good, drive back was certainly better than the drive there , nice to meet you.