Recent content by tricky1964

hi dox i dont know which gen bike you have but what i do know is that from hearing the same old story about the front valve in the exhaust downpipes fail,they start to rattle which only get worse over time and thats why i changed mine and i decided to replace the full system .and as for the full...

its not bad with db killer in ,and for fueling i have a pcv and custom map on dyno making a heathly 193 at back wheel :chuncky:

Sent from my iPhone using Tapatalk

Hi I brought a full system Leo vince factory around ?650 but loud with baffle out Sent from my iPhone using Tapatalk

Too true only remove axle from r/side has quoted in the service book manual [emoji122] Sent from my iPhone using Tapatalk

The joys of ownership of the bmw [emoji23] Sent from my iPhone using Tapatalk

Good shout buddy I had just this problem on my r1big bang ,,no free play on the pin to master cylinder [emoji106] Sent from my iPhone using Tapatalk

These settings are for the generation 2 from 2012-14 Sent from my iPhone using Tapatalk

Sorry mate front axle torque setting is 50nm my friend and rear axle is 100nm[emoji109] Sent from my iPhone using Tapatalk

Torque setting is in the back of your service book .front axle is 100nm I believe but somebody will confirm that on here [emoji106] Sent from my iPhone using Tapatalk

Undo calliper bolts then apply front brake lever hold lever in then tighten the calliper bolts with hold front brake lever in . In doing this should align the calipers Sent from my iPhone using Tapatalk

I will try mine this morning to see how mine spins without even touching the front brake lever since last ride yo check how mine spins buddy [emoji109] Sent from my iPhone using Tapatalk

Pads swollen I guess, contaminated? Sent from my iPhone using Tapatalk

Pads condition? Sent from my iPhone using Tapatalk

Hi is the wheel cocked slightly ? Sent from my iPhone using Tapatalk