How did the airbox sensor fault present itself?
I will have to pay attention to my '23 in the heat at Mugello!
Gen4 2022. Oil leak.
- Thread starter LeDuke
- Start date
Help Support S1000RR FORUM:
I will have to pay attention to my '23 in the heat at Mugello!
I think mine has gone. Got a small leak coming from around the same area. Sadly my bike's warranty just expired 
Oh and local BMW dealer is fully booked until 9 April. So no riding it for me
Oh and local BMW dealer is fully booked until 9 April. So no riding it for me
Had my call back from BMW today. And it is the oil pump that has gone. They're asking HQ if there's any goodwill available to change the part.
Oil/Water pump is the same part - they seem to be a weak link. Because so many have been replaced I would hope they do approve it.
Coyotegsxr
Active member
I’m not an expert, but I am fussy about my bikes.
The oil leak caused by a faulty/unseated seal in the oil pump sounds like a manufacturing fault. The fact that it affects some but not all suggests this isn’t a design fault, but an assembly issue. I wonder if, once it is wrong the casing is distorted. If so, repair by replacement of the pump and/or seal with generous smear of sealant will only work till the sealant is worn away. If this is the case, the whole sump and pump are screwed and will need replacing. It may knock on to other components up stream. That could get v expensive.
On the knocking forks with weeping seals. When I changed my S1000RR for a new one 2 yrs ago, I was sensitive to the issue and loosened all the front axle bolts and bounced the front. Then I realised that unless the semi active suzzies were on, this would make little difference. So switched the bike on, bounced it on the front forks and then with the suzzies still on, tightened the axle bolts and pinch bolts as per the manual. No leaks and no knocks so far.
The oil leak caused by a faulty/unseated seal in the oil pump sounds like a manufacturing fault. The fact that it affects some but not all suggests this isn’t a design fault, but an assembly issue. I wonder if, once it is wrong the casing is distorted. If so, repair by replacement of the pump and/or seal with generous smear of sealant will only work till the sealant is worn away. If this is the case, the whole sump and pump are screwed and will need replacing. It may knock on to other components up stream. That could get v expensive.
On the knocking forks with weeping seals. When I changed my S1000RR for a new one 2 yrs ago, I was sensitive to the issue and loosened all the front axle bolts and bounced the front. Then I realised that unless the semi active suzzies were on, this would make little difference. So switched the bike on, bounced it on the front forks and then with the suzzies still on, tightened the axle bolts and pinch bolts as per the manual. No leaks and no knocks so far.
- Joined
- Apr 29, 2017
- Messages
- 1,272
- Reaction score
- 17
I’ve found if you present the dealer with evidence off the web that it’s a known problem, they pass it on to BMW and the mothership replace the part even when out of warranty. You just pay for labour. I had the leds on the the bottom of the dash on my Gen3 start to burn the dash. Known problem and BMW were on their 3 design of the circuit board from memory when my clocks were replaced a couple of years out of warranty.
Well I didn't need to create an argument. BMW have agreed to cover the parts cost. Dealer messaged today saying they hope to have all parts by end of the week and I can have bike back at the weekend. Not sure the weather will find that agreeable though. Can't make up its bloody mind
Dreaded water/oil pump got me. Going in on the 29th to be done. 8,500 miles
