Fitting new screen 2015 S1000RR

S1000RR  FORUM

Help Support S1000RR FORUM:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

GixxerChuck

Forum Vendor
Joined
Apr 6, 2014
Messages
759
Reaction score
0
Location
Southend
Screen is a Puig double bubble dark smoke
Easy job this one. M20 torx is only tool needed.
First remove the 6 bolts (front 2 don't have to be removed but need loosening)
Remove the screen by sliding it up and towards the back of the bike.
The standard screen has 4 rubber bits that have a nut inside.


Just push these out from the bottom (rotating can help)

They then get put in the holes for the new screen

Push the rubber bits in through the holes from the top of the screen


Slide the new screen down and towards the front of the bike aligning the holes
Screw the bolts loosely in until they grab in the nut

You only need to finger tighten the bolts with the torx bit and the nuts will compress and seal the screen on

Job done
 
Last edited:

Latest posts

Back
Top