GixxerChuck
Forum Vendor
Screen is a Puig double bubble dark smoke
Easy job this one. M20 torx is only tool needed.
First remove the 6 bolts (front 2 don't have to be removed but need loosening)
Remove the screen by sliding it up and towards the back of the bike.
The standard screen has 4 rubber bits that have a nut inside.
Just push these out from the bottom (rotating can help)
They then get put in the holes for the new screen
Push the rubber bits in through the holes from the top of the screen
Slide the new screen down and towards the front of the bike aligning the holes
Screw the bolts loosely in until they grab in the nut
You only need to finger tighten the bolts with the torx bit and the nuts will compress and seal the screen on
Job done
Easy job this one. M20 torx is only tool needed.
First remove the 6 bolts (front 2 don't have to be removed but need loosening)
Remove the screen by sliding it up and towards the back of the bike.
The standard screen has 4 rubber bits that have a nut inside.
Just push these out from the bottom (rotating can help)
They then get put in the holes for the new screen
Push the rubber bits in through the holes from the top of the screen
Slide the new screen down and towards the front of the bike aligning the holes
Screw the bolts loosely in until they grab in the nut
You only need to finger tighten the bolts with the torx bit and the nuts will compress and seal the screen on
Job done
Last edited: