stuartb
Well-known member
This might help others if removing front indicators for track purposes..pretty sure 2009-18 are all the same, so the snap connectors to the loom are mounted at the top of the rad and getting to them is a total pain the arse, you have to strip off crash bungs (in my case) and both side panels. So I decided to snip the cables and solder on 2 x Two Pin M/F connectors.
Used heat shrink tubing for insulation purposes and to strengthen the joints.
Cable tied the out of use flex to the breather tubes on either side, I can refit both in 5 minutes..
I bought these from aliexpress last year when I was rebuilding that ZX10 and had some left over..I knew they'd come in handy [emoji3]
Sent from my SM-G998B using Tapatalk
Used heat shrink tubing for insulation purposes and to strengthen the joints.
Cable tied the out of use flex to the breather tubes on either side, I can refit both in 5 minutes..
I bought these from aliexpress last year when I was rebuilding that ZX10 and had some left over..I knew they'd come in handy [emoji3]
Sent from my SM-G998B using Tapatalk
Last edited: