Front indicators G1/2/3

S1000RR  FORUM

Help Support S1000RR FORUM:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

stuartb

Well-known member
Joined
Sep 26, 2015
Messages
8,858
Reaction score
13
Location
Dumbarton, Scotland
This might help others if removing front indicators for track purposes..pretty sure 2009-18 are all the same, so the snap connectors to the loom are mounted at the top of the rad and getting to them is a total pain the arse, you have to strip off crash bungs (in my case) and both side panels. So I decided to snip the cables and solder on 2 x Two Pin M/F connectors.

Used heat shrink tubing for insulation purposes and to strengthen the joints.

Cable tied the out of use flex to the breather tubes on either side, I can refit both in 5 minutes..

I bought these from aliexpress last year when I was rebuilding that ZX10 and had some left over..I knew they'd come in handy [emoji3]

ae405a57a56d062b35fda7848c1f8a9f.jpg
58f6266f1131b4d7b1cd32c0698181b4.jpg
d230b5cfb773d332a354374c4aee2330.jpg
e0cc06a1adcef2cb6514e627f110ec8b.jpg
a993d3d2da3ae012e0c4a347bac0d21c.jpg
b38a0c91d293f02037bc21120b62a183.jpg
0f513097ff4b3ad08b2856ff1da24975.jpg
31aefd39604bcf1d3ac2120b183b95f5.jpg


Sent from my SM-G998B using Tapatalk
 
Last edited:
Back
Top