Pulled the airbox velocity actuator off by mistake when removing the airbox earlier. Getting the actuator pin lined back up with the locator on the velocity stack arm was a bit of a pain. Essentially i lifted the stacks to their 'up' position which meant the motor just about lined up with them, but there was quite a lot of resistance as i clamped the motor down with two locked together. The stacks are now in the 'up' position.
Just checking i've not done something stupid here, but tbh i can't see how else the two would line up at all.
So, when the bike is off, do your velocity stacks sit in the 'up' position... as in, they are separated from the main tubes.
Just checking i've not done something stupid here, but tbh i can't see how else the two would line up at all.
So, when the bike is off, do your velocity stacks sit in the 'up' position... as in, they are separated from the main tubes.