Evotech radiator and cooler guard Gen3

S1000RR  FORUM

Help Support S1000RR FORUM:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

KMAC77

Well-known member
Joined
Apr 29, 2020
Messages
219
Reaction score
0
Location
Leeds
So I?m hoping someone is wiser and better with tools than I am. I?ve bought an Evotech guard set and the radiator guard seems a bit wide. Is it possible I was sent one for a Gen1/2? Or are they all the same?

Kris
 
I fit mine and they weren't too bad tbh.
The worst bit is getting all the holes to line up in the bottom of the radiator.

Rob.

Sent from my SM-N960F using Tapatalk
 
Managed to do it, what a pain that was. Although it would have been wise to check the instructions for the cooler guard before I had fitted the radiator guard. Finding those holes was bad enough once.
 
I found them a good tight snug fit and much happier than with my old cheap chinese ones as there is a bigger gap to allow air flow between the guards and rad/cooler and they are much stronger and have a better powder coated finish to them.
To fit is a bit jiggery pokery to make sure they go in place without scratching or damaging anything. The rad guard clips at the top are tight.
I did remove most of my fairing and gave it a thorough clean before installing.

Useless Chinese guards.jpg

Fairing removed.jpg
Instructions can be downloaded in following links
Rad guard
https://evotech-performance.com/col.../ep-bmw-s-1000-rr-radiator-guard-2015-to-2018

Oil cooler guard
https://evotech-performance.com/collections/all/products/ep-bmw-s-1000-rr-oil-cooler-guard-2015-to-2018
 
Back
Top