Just in the process of rebuilding my bike (gen1) but using gen3 panels. I've got a query on the tank side panel fit, on RealOEM it shows to use a separate C-clip as seen below:
But this seems to foul the original c-clip used on the tank:
Is does look like I can almost use the same body screw straight through everything and into the tank (if I use a little pressure to get them closer), forgetting the clip on the side panel.....
Can anyone check on their Gen3 and let me know how it's done please.
thx
Chris
(p.s. sorry if this seems like a daft question, but it's been seven years since I looked at my bike, so I've forgotten a lot! lol)
But this seems to foul the original c-clip used on the tank:
Is does look like I can almost use the same body screw straight through everything and into the tank (if I use a little pressure to get them closer), forgetting the clip on the side panel.....
Can anyone check on their Gen3 and let me know how it's done please.
thx
Chris
(p.s. sorry if this seems like a daft question, but it's been seven years since I looked at my bike, so I've forgotten a lot! lol)