Sharpedge
Well-known member
- Joined
- May 25, 2013
- Messages
- 67
- Reaction score
- 0
I need to pick up a torque wrench for setting the rear wheel nut. I also need to set the main bracket bolt on my bursig stand. Currently this is set to tight-ish (set with adjustable wrench and a rubber mallet as I did not have a socket big enough (I know, cringe worthy and I should know better). The rear wheel nut is 34mm (100nm) and the bursig nut is 24mm (150-200nm). With a 34mm socket I would normally go with a 3/4 socket size but the torque value is quite low. There is quite a big price diff between the 1/2 and 3/4 sockets and torque wrenches. What are you guys using?
I was thinking of getting Teng
http://www.teng.co.uk/1292ag-e4r-te...i-directional-torque-wrench.html#.U2AY3PldXRQ
or
http://www.teng.co.uk/3492ag-er-ten...i-directional-torque-wrench.html#.U2AZVvldXRT
I was thinking of getting Teng
http://www.teng.co.uk/1292ag-e4r-te...i-directional-torque-wrench.html#.U2AY3PldXRQ
or
http://www.teng.co.uk/3492ag-er-ten...i-directional-torque-wrench.html#.U2AZVvldXRT