Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums
  • nick parton's Avatar
    Today, 05:23 AM
    morning sorry not about much yesterday with work. Im based in Paignton i have spent most of my riding years on japanese bikes then the last 4...
    3 replies | 42 view(s)
  • DrIoannis's Avatar
    Today, 04:48 AM
    As promised thanks to tyre_doctor@dunloptyres.com and Alex above. Now the chalenge is to translate those nr to fit the Slip Correction in...
    5 replies | 102 view(s)
  • MoranC1's Avatar
    Yesterday, 11:25 PM
    MoranC1 replied to a thread Good morning in S1000rr Garage
    Its more of a novelty, will be fun at kirkiston haha. Yea im lisburn bud. Havent tried the launch control on mine yet tho. Must give that a whirl too
    5 replies | 190 view(s)
  • stuartb's Avatar
    Yesterday, 10:11 PM
    Yea I'm the same.. never had any probs when pads changed, I always do it myself tho, clean out the calipers thoroughly and replace the fluid at same...
    5 replies | 44 view(s)
  • Budgie's Avatar
    Yesterday, 10:00 PM
    Budgie replied to a thread Hello!! in WELCOME AREA
    Welcome to the forum mate, good to have a fellow sheffielder on board.
    6 replies | 78 view(s)
  • v2simon's Avatar
    Yesterday, 09:57 PM
    v2simon replied to a thread Fresh Start in WELCOME AREA
    Aaargh! Quite a difficult question to answer - I got the 675 AFTER riding the RSVR for eight years. I met quite a few ex-RSVR drivers in the same...
    3 replies | 71 view(s)
  • soofsayer's Avatar
    Yesterday, 09:54 PM
    Never had any issues when changing pads myself, pretty much good to go after a few miles, on every bike I have owned. If you tested them first and...
    5 replies | 44 view(s)
  • cinnabull's Avatar
    Yesterday, 09:37 PM
    Heyup Guys Well I haven't actually got a S1000RR quite yet, but have a deal provisionally set up or a 2017 rr sport in grey. I currently ride a...
    0 replies | 6 view(s)
  • alex's Avatar
    Yesterday, 09:06 PM
    If they are the same pads as before they should only need 50-100miles. Needs some long slow deceleration as wel as a couple of good hard stops to...
    5 replies | 44 view(s)
  • bmwbadboy's Avatar
    Yesterday, 09:06 PM
    unless you on a track and trying to brake from 250kph to 50kph, I wouldnt even think about it, considering you've done only 200miles. just take a...
    5 replies | 44 view(s)
  • r25sti's Avatar
    Yesterday, 08:56 PM
    a few miles and mine are usually good. i use oe brembos on the road bike. some pads need the discs cleaning up before running them in all depends on...
    5 replies | 44 view(s)
  • Huge's Avatar
    Yesterday, 08:54 PM
    We have them on Brighton seafront, and I don't mean men in wigs and high heels. It's bonkers. - @Soof. How is pic of the month decided? Is it no....
    17 replies | 596 view(s)
  • Huge's Avatar
    Yesterday, 08:44 PM
    ... to bed in for road use. Been feeling a little vague even after 200 miles, but I'm not much of a 'braker' TBH. Did a few 'big stops' early on to...
    5 replies | 44 view(s)
  • RyS1000RR's Avatar
    Yesterday, 08:13 PM
    Absolutely nothing beats time on a Dyno and custom mapping for whatever fuel management system that you are using.
    13 replies | 230 view(s)
  • Oli's Avatar
    Yesterday, 07:34 PM
    Oli replied to a thread EML after PCV install in S1000rr Garage
    A full system will always be lumpier at low revs than a stock system with a catalyser and 2x exhaust valves, due to the massive difference in...
    13 replies | 230 view(s)
  • M12NTE's Avatar
    Yesterday, 07:20 PM
    Hi Oli. Thanks for the reply. Interesting hearing your thoughts on the system with standard fuelling. It did run quite nicely, a bit lumpy on...
    13 replies | 230 view(s)
  • Oli's Avatar
    Yesterday, 06:55 PM
    Oli replied to a thread EML after PCV install in S1000rr Garage
    Thatís one of the good things about fuel modules, in that you can always sell them on. I have a PCV on my 15 MY Gen 3 and it does the job, itís...
    13 replies | 230 view(s)
  • alex's Avatar
    Yesterday, 06:51 PM
    alex replied to a thread EML after PCV install in S1000rr Garage
    It does some learning, Performance Parts Ltd supplies a decent map with it as far as I know. - Alex
    13 replies | 230 view(s)
  • T8y's Avatar
    Yesterday, 06:50 PM
    T8y replied to a thread Good morning in S1000rr Garage
    Havenít tried the pit lane limiter, but have seen a video of it in action. Iím saintfield direction. Iím guessing you must be Lisburn
    5 replies | 190 view(s)
  • M12NTE's Avatar
    Yesterday, 06:47 PM
    Thanks for the info Alex, really useful. It sounds like the rapidbike unit is the way to go. Am I right in saying that it can self learn and...
    13 replies | 230 view(s)
  • MoranC1's Avatar
    Yesterday, 06:24 PM
    MoranC1 replied to a thread New from N.ire in WELCOME AREA
    New addition: and YES that is the ULSTER GP track, it happens to be my local road 5 mins from my house:woot:
    7 replies | 114 view(s)
  • MoranC1's Avatar
    Yesterday, 06:16 PM
    MoranC1 replied to a thread Good morning in S1000rr Garage
    Looks awesome T8y! What part of N.i you from? around belfast? Wgilst i waited to collect my Gen3 i sat and youtubed how to adjust the menus and...
    5 replies | 190 view(s)
  • MoranC1's Avatar
    Yesterday, 06:12 PM
    MoranC1 replied to a thread New from N.ire in WELCOME AREA
    Hey Oli, I deffinatly enjoy Fast riding as youd guess. Done a few track days over the past few years. Im only riding 3 years so my first bike was...
    7 replies | 114 view(s)
  • Steve SGR's Avatar
    Yesterday, 05:46 PM
    Steve SGR replied to a thread Hello from SGR in WELCOME AREA
    Cheers :-)
    7 replies | 51 view(s)
  • Steve SGR's Avatar
    Yesterday, 05:43 PM
    Steve SGR replied to a thread Hello from SGR in WELCOME AREA
    Thanks - I've had a good mix of bikes over the years, and enjoy riding pretty much anything. Have an old GS at the moment, but seriously considering...
    7 replies | 51 view(s)
More Activity